Cool K9 Wiring help.

No sir, you missed I have a dual battery setup already and going to take power from the 2nd battery.

I have this system already installed. With 2 Full Throttle Batteries
https://www.**************/collecti...off-road-trd-pro-complete-dual-battery-system

Oh snap I see what your saying..... humm

 

But 99% of the time if she is in it I am going to leave the truck on.

I can always open the window and turn the fan on if I turn off the truck.

But yeah it would be nice to have power for that window coming from the 2nd battery.

 

30 amp HOT provides juice to relay
30 amp ACC/ON (Shared) would be off.

 

Here ya go:

 

So where is this located? I should be able to cut it and run a wire from the 2nd batter to the relay and now it will always have power.

But what wire to cut and where is the relay?

 

ok so just jump purple and red wire on the N35 relay

 

Diode inline with the wire to relay coil.
Jumper wire (20 awg) from hot source of relay.
Blue wire from module to pink wire.

 

And do NOT forget the diode on purple.

 

ok

add something like this inline.

 

yes

 

ok sounds good thank you!

 

Small gauge wire for the jumper. (same size as the purple & pink wires)

 

sliding window relay base.

 

ok

 

I got nothing to add except, Say a big thanks to @caribe makaira
Nice of you to help out a guy and his pup.
You are definitely an asset to this forum. Thanks buddy

 

Rear Slide Anytime. Careful not to drain battery

Jumper (20 awg) 5 to 2
Diode on purples

 

@caribe makaira Tanks for all your help!!

Here's a little install video. https://youtu.be/9d8Wtvk0OKw


Here is a video with emergency lights on. https://youtu.be/PkkjJzwnMdY

 

Nice, now the Pup can stay nice and cool.
Always nice when a project is completed successfully.

Thank you for updating us.