1GR-FE fuel rail solution

After I turbo charged my xrunner I was looking for a fuel rail solution. Based off images alone I pulled the trigger and purchased a fuel rail for 2grfe from Radium. Injector spacing is the same and 3 out of 4 attachment points are the same. there was a difference in required attachment spacer height from 1gr to 2gr, so i machined the spacers required and purchased the fittings i needed to make the install work.

 

these are drawing specs i made, simple design and can be improved by maker

 

Nice work

 

final assembly, i will post required bolt sizes and fittings i purchased. but essentially you can buy the entire radium full kit and it would be direct install if using factory fuel feed line.

 

Maybe the mods can move this thread to the performance section. May get better exposure.

Good job for taking the dive to make it happen!

@Lucario Runner

 

Called it, I've always assumed the 2gr would work but never followed through. Thank you @Xrunner2nv for making the virgin run.

 

Yes you did.

 

@tcBob can dis thread be moved to the performance section pls?

 

Does this mod fit under a supercharger?

 

Good question and will this fuel rail fit the 650s

 

Radium now makes one for the 1g

 

Correct you are. A new thread should be made for that.

 

I posted under performance Tor