"Complete" Suspension Overhaul

I've been trying to get parts to replace my suspension and wanted to see if I'm overlooking anything.

So far I have:
Bilstein 5160s
Bilstein 6112s
Deavers u420 Leaf Kit
Total Chaos UCAs

Do I need anything else? Bump stops?

 

ECG’s bushing? Needle Bearing. I did Wheelers super bump front and rear with flip kit in rear. Love it.

 

Extended brake lines.

And consider going higher spring rate if you plan on adding steel bumper.

I have same set up but with 700lb springs and Dakar leafs

 

Replace all bushings and concerned hardware (e.g., nuts, bolts, washers).

 

You don’t need extended brake lines. You only need those when going outside factory geometry which you aren’t with that setup.

You also don’t need bump stops as like mentioned above this is basically a factory setup.

However I would recommend the ECGS bushing as the needle bearing is prone to fail.

 

Bump stops will help if you off-road