Sandman614's #expoenough Build

Last trip to URE I hit the rear diff drain plug pretty rough, and pivoted the truck on it. Turns out it was leaking afterwards.. It's been getting harder and harder to get a socket up around the hex so I replaced it with a 10mm Allen plug.

$14 12157-10010 Toyota Oil Drain Plug Crushable Steel Gaskets Set of 10 OEM 12157-10010

12157-10010
90341-18021

 

I did the same and it’s been perfect since. Keeps it nice and close.

 

Might get up the gumption when I get around to replacing my rear axle bearings to replace the orings in my rear locker.. Been leaking out out the air line since it was installed.. It's not leaking air, but the gear oil mess is quite annoying..
https://www.google.com/url?sa=t&sou...oQFnoECAMQAQ&usg=AOvVaw0hwiTTnt0_4ijqNu89H875
1 For replacement O-rings use only BS136 Viton 75.

 

@EricL

 

I think I follow most of this. I may have some questions on specs and stuff soon if you don't mind me asking.

 

Honestly getting the outboard installed was the hardest part

 

48 pages later, I found it!

But I don't think you have it setup like this any longer, do you?

I'll keep reading.

 

I moved the panel to the unistrut roof rack, but everything else is the same

 

You have a wealth of information in here. I've bookmarked a couple of things for later and just ordered a set of Quickfist ratchet clamps.

Also...

 

#maintenance catchup
3/20/21 281215 air filter
9/23/21 290169 oil change
1/27/22 295492 air filter
1/30/22 295710 spark plugs, coil dust seals, fuel tester port install *plastic coating on fuel line too damaged and cut off

 

Getting ready to go after another oil leak, seems like the front crank seal is leaking. Just replaced the same seal on Her Majestys Jeep and made up this tool to hold the crankshaft pulley.

 

Man I hate putting this skid plate back on... Got the crankshaft seal replaced and cleaned up a bunch of the caked on crud. In doing so I found another leak up behind the power steering pump on the timing cover.. There's also a bit of a Ridge on the snout of the crankshaft pulley, so we'll see how well the new seal works. The new seal from Toyota is a Koyo MK042F15

 

3* Exhaust cam gear results. Here's my before and after mileage for a year. No real power gain has been noticed, less engine braking when letting off the gas gives a feeling of less rolling resistance.
*I run 2 sets of tires 255/85/16MT and 265/75/16AT, some low numbers are offroad

1 year before Cam gears Average 14.64397mpg


1year after Cam gears Average 15.30167mpg

 

Hey Sandman,
On the one picture, I saw a large pipe going into your cab......what was it?

 

Use the Quote button on the post you are talking about

 

lots of fantastic mods. I wish I had the time and room.

 

Ok thanks

 

Ok now the picture is there. It's @Mach375 "different approach to a snorkel" https://www.tacomaworld.com/threads/different-approach-to-a-snorkel.266449/

 

So what is that pipe that looks like it's going into your cab? Is that an internal cab snorkel?

 

That's a nice setup. I did see the guy @ pelfrey built, his setup. His was a V8 4runner right?
I think we have the same color truck. But do you have an access cab/dc?