ARE cap - seal replacement. Front Drop Down Window

I contacted 'a dealer' (No names yet) about getting the seal fixed on my ARE MX front window.
After some 'research' they said go to Lowes.

I get water into the bed.
It shows in the window frame, drivers side, when I drop the window.
The seal 'looks' glued into the window.

I sent a question to ARE.
I know... they will tell me to deal with the dealer. Now, that puts me in a catch 22.

Before I pull the cap and pull the window ...
I like to know what I am looking at first.

Anyone fix a front window seal on these?

Oh, I am sure I am past warranty. I think.

Ken

 

ARE asked me for photos to sent the the tech team.
I sent photos.

 

Subbed. One of my ARE side slider windows leaks and I suspect the seal. I’d love to know the best way to re-seal them after removing them

 

I am hoping to not remove it. The front means I have to remove the cap to access it.
I ordered a side Win-Door to replace the driver side sliding window. That item came in, but I am not going to schedule that until they can fix the leak. I would prefer to not fix the leak myself. I am hoping ARE says the seal is defective.

 

ARE got back to me. They think the 'weeping holes' are plugged up.

 

Where are the weep holes?

 

Sorry for the delay.

I looked at the window frame with the door dropped.
The driver side was plugged.

There are 4 slots, 2 on each end, passenger and driver side about 6-10 inches from the end. They can be seen if you lift the seal a little bit, or if you shine a flashlight from the outside.

 

Thanks.