What Have You Done To Your 3rd Gen Today?

Got the rear and front right part of my lift in. Ran out of daylight so I will do the drivers side tomorrow after work.

Its the trd pro suspension with the eibach lift kit. Im about 2.5 inches over a stock trd offroad now (1.5 over a stock trd pro). I got a little bit left of my tires, so I am going to run them till about January, then buy new bigger ones. They are not terribly worn out, but they are cracking between the treads pretty good.

 

Installed the 4xinnovations sliders and rear bumper. There may have been some cussin n swearin, but they're on. Solid doesn't begin to describe them. Still waiting on SSO for the front.

 

So how crooked is your truck?

 

Not too bad, you can tell when in the truck for sure. Its about 1-1.5 inches higher on the passenger side right now.

 

Other than the two piece bed sides that rotted out, these were great little trucks, easy to work on, and looked good too!

 

Got the truck back after the exhaust reroute and had the ARB locker and compressor wiring and switches installed.

huge props to Jason (@Speed Freek) for the work.

finished installing the rest of the RCI skids.

also got to play around with the Morflate.

4 minutes from 15psi to 36psi.

 

Bilstein 6112s front (5/6 clip setting), 5160s rear, JBA UCAs, and Icon RXT Stage 1 leaf pack. Absolutely loving it!

 

Are those the bolt on 4x sliders? Usable as a step for front and back doors?

 

They're bolt on. They're high, so usefulness as steps, not so much, but you can step on em to get access to racks, etc.

 

ALWAYS open the Input bolt first to make sure you can get fluid back in it. Ask me how I know.....Thankfully cast iron transmissions have a giant hole up top for the shifter as it became the Input point.

 

Got it, so useable to stand of at least. I really like the look of the 4x as they have some angle but they built the plates in nice and flat. Good distance from the sliders to pinch weld? I'm looking for some robust and good looking sliders and I keep coming back to the 4x ones.

 

Installed total chaos bed stiffener. Used Graphite on my RSI cap locks and it made it a lot easier to insert the keys. Also slapped these magnetic led light bars onto my canopy.

 

Well!!! What the heck is that other stuff? What is the remote for.

We all got to know.

 

Remote is for the lights to turn on and off.

 

OK

 

Finally got my wheels! Icon Rebounds!
Spent a few hours making custom center caps for them.
Now I have Icon "TRD" wheels! LMAO!!

 

Did the same yesterday

 

I added a very important sticker.

 

Did a double take on the cheeseburger...I thought who would wrap a steering wheel with a look a like greasy hamburger wrapper!

Good One.