Quick U joint question

I have a 2015 TRD OR DCSB with the 4.0, greasing my "propeller shaft" (that still cracks me up) and noticed the one U joint doesn't have a zerk fitting (the one on the forward side of the transfer case that has the shield over it), are there some that dont (maybe a replacement that is sealed?)

 

There's one there unless the joint has been replaced with a sealed unit or it fell out, it can be pain to get at though.

 

I rotated it a full 360 and looked with a flashlight....dont see one

 

Can you see or feel a hole in the center of the joint where one would go, some of them are on the end of one of the caps.

 

Front driveshaft from tcase to front dif have zerk fittings in THE CENTER of the u joint not on the end caps like the rear driveshaft.

 

Hard to get a good pic, but no fitting, and no noticeable hole i can see or feel

 

Prerunner or 4x4/4wd?

If you're a PreRunner, I dont think you'll have that zerk there.

 

4x4

 

If your driveshaft was replaced by Toyota they now use 2 sealed u joints. Happened to mine and I thought I went crazy.

 

Yea if replacing definitely get zerks