1st Gen Lunchtable Thread - General Discussion

on one hand I want to be there

on the other it looks cold

 

I think these might be the locking hub part numbers from Toyota:

Gasket - outer
43422-60010


Gasket - flange
43531-60010


not an O-ring, but kinda like an oring (ribbed...)
43532-60010

 

Packing Shaft

 

Eh 40’s

 

Here I thought I took pictures of all the part numbers.

You're right about that ring too, there's a groove in it -



I used Sil Glyde from Napa on that, and got the gaskets from Napa as well.

 

Oh I should check napa. Dealer here is slow as balls.

 

I sourced an extra set of detent ball and springs from either Yotashop or some other place that begins with 'Yota'

New ball shown above, here's the new spring -

 

I believe marlin has the detent ball and spring as well

 

Last but not least, you can replace the 2 bolts at the end of your CV axle.

They're a back up to the retaining ring in the event that they fail. Really I've never seen those bolts in place myself but that's how they came brand new -



I've got a set myself in a baggie but I never did convert so they're in storage

Part number for your convenience -

 

My bolts seem to be long gone

 

PSSSSSSSSSSSSSSSST, too much grease

 

How many ugga duggas for dem bolts?

 

One of these days you’re gonna post up about how you went to your storage unit and found a whole Tacoma you forgot you owned hidden behind a couple of stacked couches.

 

I'll make sure to send the Canadians that last worked on it a strongly worded letter.

 

Damn canuks only know two things, hockey and no wait just that.

 

Syrup

 

Yeah that was a set I got from a junkyard Taco; not surprised the engine was gone within the first half hour of arriving but the hubs were still there

 

Is Log Cabin Canadian?

 

And it'll have way less rust than @Empty_Lord could ever own

 

All of them