Custom Square Tube Bolt-On's

Morning gang!
Finished up some square tube sliders with a buddy of mine. Loving how they turned out. The goal was to get the beefy and unique look all while being durable. We also wanted it to be strong enough to jack up the truck in a pinch.

Truck, as you can see, is still pending a lot of further time (and money), but went without the angle so the wife can use it as a step once the truck is lifted and take-off's are swapped out.

Well, we accomplished all of my goals and then some!

If any of you are interested in the area, my buddy is set to make more of them, and does great work in general, just as a shameless plug.



A few photos from the build itself:

This was early on, throwing a jack underneath and see how the mounts held. Didn't even budge lifting up the driver side of the truck.


Don't mind how far these photos make them look like they stick out. The angle I took them at was to show the joints and progress, and also make them look like dumbo ears.



And when both sides were finished / getting paint (Oh, and the jig to make more if there's interest):

 

Welcoming feedback on these - also, will go ahead and plug the brand, not for advertising, but strictly for credit for the work. I just sat back and provided the rig and "opinions."

For anyone in the AZTW community, Brandon will take great care of you, very knowledgeable and talented guy, great communication, and way better than some of those "print and repeat" guys that we all have run into in the scene.

AZ Mobile Fabrication - 602.421.9897