Hello

I have a couple of questions I have a 2003 Toyota Tacoma 3.4 L I was replacing the timing belt I made sure I lined up everything properly the crank and both cams before removing the belt installed new belt make sure the lines lined up with the cams and the crank after rotating the engine four times my marks on the belt were off from both cams and the crank but the cam sprocket’s and the crank were in line it’s just the belt marks were off will this pose a problem?

 

Welcome to TW

 

don't worry, It will work. Had the same thing happen to me on a 2002 3.4L first time I changed the belt too. Turned it over a few times and nothing lined up anymore.
My math whiz brother happened by and quickly calculated it would take several times for them all to line up again. I finished putting it together and it ran great.

Welcome to the forum!

 

Petty sure it’s normal.
I’m betting if you turn the engine over enough the marks will eventually line back up.
See here for same question.
https://www.yotatech.com/forums/f120/5vzfe-timing-belt-help-266720/#post52063032

Also, the truck doesn’t know where the BELT marks are, only the cams and cranks marks.

 

Welcome to TW!