2nd gen Track width and alignment help

Hello everyone. I've tried some searching and I can't find the 2WD track widths front and rear.

I've found 65" for 4x4s but that's likely not applicable to the 2WD 5lug versions which I know have different axles.

My alignment question is in regards to centering.

Does anyone know if there are points on the truck that are centered and or where there should be two points that are the exact same distance from center or from where they mount to the outer hubs? In some cases, vehicles have inner or outer tie-rods that are exact mirrors of each other but I'm not aware of such parts on this truck. I suppose I could set the lower control arms to zero camber and measure from bolt to bolt and lay down some lines.

Bc my jack-stands are tied up under my BMW, I didn't try to align with the string method yet and really only with a jerry rigged laser to Longacre racing Toe plates that only touch on the tires. I need some new stuff to properly align my vehicle but knowing how to find the center of it will help in getting the front end back to where it should be after I get some good lines coming off the rear with strings and or laser.

 

I like those wheels.
What are they?

 

Thsnks! Skyline R32 GT-R oem. 16x8 +30 forged and light. Fit perfect with no spacer using 255/65/16 and OE ride height

 

Truck has pretty much never been garaged until I purchased it from my brother in law a almost 2 years ago. Work in progress.