What Have You Done To Your 3rd Gen Today?

Sounds like a badass trip! Do you have any clearance/rubbing issues with the spare and the rear window? I like the setup

 

VERY SHARP!! Love how your plate brings just enough color to make it look cool. Well Done.

 

Thank you!

 

My only complaint with the center console organizer is the plastic knocking i get when items clunk when I turn or go over bumps. I tried minimizing the sound with tape.

Its probably just me but it drives me bonkers sometimes.

 

keep trying to convince myself I don't mind the factory grille but every time I see this one I change my mind.

 

10mm

 

A little trick/tip I learned is to adhere some tool box liner to the plastic dividers. This should eliminate the rattling.
Happy modding!

 

I found a set of TRD SEMA wheels for a song around thanksgiving. Waited for a good deal on tires, and finally got them swapped last Friday.

Now I just need to figure out what to do with a set of stock rims and a set of Toyo Open Country A30s with 6500 miles on them…

 

Pic?

 

Sorry. I meant I have to replace the screws. you know the length?

 

On mine you can cycle through lines or no lines using this button on the screen when in reverse

 

If it's right over the window defroster vents, that's not uncommon if you're running the A/C at full blast.

You're most welcome... It definitely fits the K.I.S.S. principle, but it would have been perfect if they added a motion sensor and I'm still not sure what to do with the other four lights.

 

Props for a different and original location for the door flags.

 

Thanks. That's where they are on my brother's Roush f150 and I liked the look so I ripped it off. lol

 

https://www.youtube.com/watch?v=KoKfB18yxts

 

Found one of the sporadic clunks in my front end... it was a golf ball left in the center console.

Suspension is still completely boned but at least I "fixed" one issue...

 

need some opinions. I have sliders coming tomorrow. They are bare metal because I didn't want to pay $150 extra for powder coat for it just to be scratched all to hell. Should I just use normal spray paint or like a flex seal/bedliner spray for some texture?

 

I found one diagram that says #6 screw x 22mm but there’s no way that’s correct right? I know they’d be easy to find if I could just track down the right size and length.

It’s crazy how many tabs, clips, and screws I’ve lost over the years and just replaced with whatever I could find in my garage. Now I’m on a mission to replace everything correctly and it’s harder than I thought!

 

They are semi-pliable, but I bet they would snap (or worse) if you tried to bend them completely in half. They are not hard plastic like the stock ones. The hardware to attach them is much better than stock.

I went RB instead of Rekgen simply because the Rekgen instructions are wrong and have been for years. They tell you to install the front hardware in the back and vice versa. I can't stand when instructions are wrong - causes me an epic meltdown. If they can't even get their own instructions right what else are they fucking up?

 

RCI SLIDERS