What Have You Done To Your 3rd Gen Today?

My first thought was about killing a piece of safety equipment without adding back equal or better equipment, then I thought about adding an extra retro reflector on the sides to make up for the loss... Then I had an idea: wrap the entire truck in black retro-reflective vinyl wrap. Unfortunately the only stuff I found can only be had in 24in strips. Boooo.

 

I like your thinking... Beer is a grocery item...

 

What mounts are you using for your boards? I need to pick up something similar to your setup.

 

Just pulled the dash apart to install the meso vent rings and the taco garage DMM. Gonna be glad to have full use of my center vents again.

 

That’s a good lookin truck! Is that a prinsu up on top? I’ve been thinking about getting one for mine, but I’m not quite sure yet.

 

I don’t know a lot of the orange still shines through so might not be a problem.

 

It’s lined and has a ton of options and add ons which quickly add up. I’ve had it for a day now and love it.

 

Great set up, looks good. Thanks for the interior photo.

 

cleaned all the nasty crap off my bed/bed mat, hosed off the wheel wells and back axle and bed mats (lots of salt on roads here), cleaned windows.

i do trash pickup part time in the evenings so my truck was smelling baaad. usually rinse it off once a week at least but haven't in a couple months due to freezing temps

 

That's where I have mine, however I have a topper that has tinted windows. Hard to see in.

 

That’s not beer….

 

Finally replaced the anemic factory headlights and fog lights (PITA) with new Tungsram H11 + 130.
There IS a difference. I was tempted to go LED but after exhaustive research, it seems that sticking with Halogen is the way to go. H9 or H11+130. I don't want to be that guy who blinds oncoming drivers.

 

Driver side cmc. Did this myself today. Took a while because im no welder, but i think i got everything in good shape. Trying to leave the fender liner intact, used a heat gun on it. We'll see how well that works. If i end up needing to cut out that liner, i have a plan B. In Ohio everything is salted and i want to keep as much salt from inside the fender as i can.

Overzealous with the under coating spray.

I took some screen shots from @ClassyTacos how to video, that was a big help. Thanks man!

 

One of my first upgrades. One of many upgrades that should have already been part of the truck.

 

Yes indeed that is a Prinsu rack. One of the first few mods, ha.

 

Use one of your pistol cable locks.

 

Finally finished up my switchpros switch install! Puddle pods, the puddle pod switch harness and a 32” hidden light bar went in too!

All done for now..

 

Added this to my passenger visor. Problems solved.

 

Link?