What Have You Done To Your 3rd Gen Today?

Finally finished up my switchpros switch install! Puddle pods, the puddle pod switch harness and a 32” hidden light bar went in too!

All done for now..

 

Added this to my passenger visor. Problems solved.

 

Link?

 

This is another one of those mods where if you weren’t on this forum you wouldn’t ever think about. I like this better than the black vinyl overlays I’ve seen some folks do.

 

Here you go.

$3 Funny Truck Safety Warning Rules Sticker Adhesive Vinyl Window Graphic Bumper

Amazon.com: Funny Truck Safety Warning Rules Sticker Adhesive Vinyl Window Graphic Bumper : Automotive

 

$2.91 shipped. Done deal. Thanks, one of the cheapest mods I’ve done

 

Used catback showed up, pretty nice piece we will see how I enjoy the sound over the next couple days

 

Only had my Taco a couple of weeks, but got an UpTop Overland Alpha roof rack installed yesterday with the color matching grooveTek

 

Looks good! Welcome to TW!

 

What brand is this?

 

stromung “Tucker” has a nice deep tone that’s not overbearing from the short drive I took tonight. Will see how it is on the highway tomorrow

 

Got the DMM and meso vent rings installed today. Much cleaner than my previous setup.

 

I pointed my ditch lights forward a little more

 

Pictures don't do justice how long this actually took to get right. The Lightbar Kit bottoms out on the Prinsu Valance (It's a mount kit specifically for this lightbar and the Prinsu rack ) I used 5 washers and a longer M6 Bolt on each side to raise the mount up high enough to clear the valance. Now the lightbar no longer spots for low flying aircraft. .

 

Got an idea for you: take that valance off and use it to make a pattern on a sheet of Lexan or other clear UV-resistant plastic, then drop the light back down behind it. Lower profile, expensive lights are protected from highway debris, less wind noise, and more aerodynamic

 

Same here. Along with ARB air compressor and front lockers. Much cleaner now.

 

Busted out the vinyl cutter and made some decals

 

Added a TRD lift, rims and 265/70/17 BFG KO2’s

 

A lot of departments hand out free pistol locks. The Community Service Officer usually has a stash or the desk sergeant may have some.

 

Installed RCI full skid plates and rear differential skid plate. Still waiting for my roof rack.