What Have You Done To Your 3rd Gen Today?

Nice i am in matthews nc somewhat new to the area if you dont mind me asking where was this ive been to uwharrie looking for some other good spots

 

I love seeing the pictures of your travels in your posts! Have you considered making a YouTube channel like keepyourdaydream?
https://www.keepyourdaydream.com/category/youtube/

 

Super excited about getting a new soft topper.

 

I love car wash day. And minimal vaccuming was needed inside, like hardly any, only dirt was from me. The rear seat delete and dog crate back there keeps all my shepherds hair contained.

 

Now I know why they charge what they charge to have these installed. More measuring than actually installing but it’s on. Cap tracks with Overland bravo cap rack.

 

Order this, but request matte black I've requested Rich @rrentrop to offer matte black separate, instead of carbon fiber.

 

Just spend your weekends around Asheville and thank me later. Lots of great offshoots from the blue ridge pkwy

 

Went to the Toyota Enthusiasts Club meet today.

 

how did you end up mounting the rails? been wanting to do the same for a prinsu rack

 

Finally installed the Spiker hood struts. Well, I didn’t do it, my significant other did it.

 

https://www.tacomaworld.com/threads/installing-yakima-tracks-on-camper-top.483625/

check this out I got a few tips from this. The tracks I got all came with hardware of course and instructions. Measure, measure, measure. Then before you drill measure.
silicone is your friend.
Paint marker and tape.

 

Unfortunately, the diameter of the holder takes up just a litte over half the cup holder area so you probably won’t be able to fit 2 side by side

 

Brand new to the forum. Not all done today, but I installed caliraised LCA skids today. Also newish are caliraised rock sliders, and same day finished putting on RCI skid package by installing the transfer case skid.



Initially while driving I had a pretty obnoxious knocking sound after installing the transfer case skid, was worried at first I broke something, turns out my exhaust was sitting very close to the skid and they were banging at certain RPMs, so I wrapped it in exhaust tape as shown below and haven't had issues since.

 

I need to be matching. Ordered a blue compressor switch and got sent green. At least OTTRAW has great customer service. I emailed them and they should send it monday i bet.

Till then, ill get a twitch in my left eye everytime im in the truck. But, the switch does work.

 

Picked up a little “Vroom-vroom” toy on a good deal from the ‘ole Craigslist.
Quick and easy install, just takes a bit of spine yoga to plug in. This will be fun to play around with over the coming weeks.




Also did the A/C drain mod before the hot summer months hit.

 

Nice work! Welcome to TW!

 

or you could get it powder coated...

 

Drove mine today after sitting for a week driving the commuter. I did the 1000 mile oil change last week so I was able to let the RPMs climb a bit higher today. Used S mode and shifted myself through 3rd at about 4500rpm and it gets going pretty well. I wish shifts were faster though.

 

Installed my Midland MTX500 and fabricated a bracket for the Ghost antenna so I could mount it to the Prinsu.

 

Installed an Escort x50 using the PerformancePackage Mirror Mount. The write-up thread is over here.