Tool to remove LCA Bushings

I don't have a bottle jack so I figure this would be more useful in the long run. I do have a bench vice also if needed. A few reviewers on Amazon for the Whiteline bushing say they used a C-clamp style ball joint tool. Luckily my truck does not have rust.

Will this do the job? I'm good with engines but not much experience with ball joints and bushings. I need to change lower ball joints at the same time and ASAP, still on originals.

They also have a 21 piece with more adapters.

$50 Orion Motor Tech Ball Joint Press Kit, Heavy Duty Ball Joint Removal Tool Kit with 4x4 Adapters, for Most 2WD and 4WD Cars and Light Trucks

https://www.amazon.com/OrionMotorTech-Heavy-Removal-Adapters-Trucks/dp/B01N7CO50E?crid=1E0ZJFFUYUKS9&keywords=ball+joint+separator&qid=1650922239&sprefix=ball+joint+%2Caps%2C282&sr=8-21

 

I also use it on U-joints. On the BJ’s, mine struggled, With the tool engaged, I had to use an air hammer to assist pressing out the BJ with the BJ on the car. I haven't tried it on the bushings. You should have a bottle jack in the truck.