Shop Time w/T.W. Friends

Sorry to hear. Our old lab been gone about 4 years or so. Didn't have cancer but some growth at his butt. We had it removed several times. The last time he didn't recover from it. That was a very expensive pet.

 

Good morning Wrenchmen, so much I should do -- not really interested in doing any of it...

 

can't like that.

 

I swear by this stuff:

EternaBond RV Mobile Home Roof Seal Sealant Tape & Leak Repair Tape 3" x 50' Roll White Authentic (3''-50ft)

$54 EternaBond RV Mobile Home Roof Seal Sealant Tape & Leak Repair Tape 3" x 50' Roll White Authentic (3''-50ft)

https://www.amazon.com/dp/B07F9G63N8

And this as well:

3M Marine Adhesive Sealant 5200 (06504) Permanent Bonding and Sealing for Boats and RVs Above and Below the Waterline Waterproof Repair, Black, 10 fl oz Cartridge

$33 3M Marine Adhesive Sealant 5200 (06504) Permanent Bonding and Sealing for Boats and RVs Above and Below the Waterline Waterproof Repair, Black, 10 fl oz Cartridge

https://www.amazon.com/dp/B001R0GUZG?_encoding=UTF8

 

My fav part of that gif is after he pulls his hand away, you can see it blister on the left and its just about to delam right as the camera cuts away.

 

I made this drum a few months ago, the hardened dowel pins wore the hot rolled material along with themselves. The solution they came up with, put hardened bushings in it. I told the boss the first time they use it the bushings will wear the softer material and fall out.



There’s theory and there’s application. Prove me wrong boss man

 

Whole disk needsto be hardend..

 

Hmmmm

 

I needed to move this wire to the bottom so I unspooled it.

 

Yeah...may want to leave a couple of wraps on that set up

 

WTF??????

 

We need to change the kool aid around here. Seems like we take 1 step forward and two steps back.

This is an original drum from Switzerland. It’s metric hex inside and has 4 rows of blades.




We made the square one and the customer said make it like we did for another customer that had 5 rows of teeth and the square inside. We made one and they didn’t say anything about it hitting the cover.




Boss man copied their cover and we had a fab shop make two. I put it in a few weeks ago and it fit great. They didn’t have the blades on though. Here’s the shaft it goes on we made and one of the new covers.





Customer just came by and said I told you it was hitting




Time to make a bigger cover

 

Looks perfectly machined in place to me

 

Imagine the racket when they fired that thing up

 

They used it like this for a job

They broke the front tab off, it was held on by one 6mm bolt on the back side

 

Is that because holes got worn out?