NYC/NJ CMC CMR Shop Recommendations

Hi all, recently just shoved a set of 315’s under my truck knowing I would need to do a CMC or a CMR. Any recommendations for decent shops in the NY/NJ area that do a good job? Thank you in advance

 

Yea I am in the same boat.. I just bought 285's -12 offset and am anticipating a CMC. I can do most of the work just lacking the welder or knowledge to weld. just purchased CMC plates from BAMF to help out a bit. I am also located near Morristown if anyone knows a local shop?

https://www.tacomaworld.com/threads/bamf-cmc-plates-cab-mount-chop.192527/
https://www.bayareametalfab.com/CMC-Cab-Mount-Chop-Brackets_p_15.html

 

So I actually just upsized from 285’s and I have the same offset, I was able to not need a cmc the last 3 years or so. Just needed to pull the caster forward a bit in the alignment and I never had an issue. This included offroad, never needed the cmc. Depending on your suspension set up you can probably get away with it

 

If you have plates I will weld them in. Doing another members this weekend. Knock a few out at one shot.

 

I should have the plates in hand Thursday (granted the UPS Gods allow it).

 

I would definitely be interested, I shot you a pm

 

Hi Guys, I know this is an old post but are there any shops in the NY/NJ area that does CMC and viper cut? Thanks again.

 

@6 gearT444E ?

 

Don’t know what a Viper cut is but I could chop and weld up the cab mount

 

I think it's trimming the front bumper for more clearance. Ill let @Jonny Mal explain it better