What Have You Done To Your 3rd Gen Today?

Looks better than my $25 Ebay pleather...

 

The Kickers were not cutting it with the Alpine amp I installed, in comes Hertz.

 

Clazzios

 

tough fuckin’ crowd!
lol.

 

Got the passenger side door sound deadened and the replaced the speaker. Audio quality is much improved.

 

This looks good , what about the back up sensors, do they have a bumper to install those into along with the blind spot monitors that are in the bumper as well?

 

https://shop.mcgard.com/products/automotive/tailgate-lock

 

Wash you truck as usual. Then You can dry it with a towel to get some of the spots to go away.
I wash it let it dry (drag a towel over it to speed things up if your in a hurry).
Then it takes 5 minutes to section spray then wipe a detailer product to give it the shine and get rid of any water spots and road grease as well.
I use this brand because some cheap stuff can leave streaks.

 

I’ll check that out thanks!

 

Installed some AVS in channel vent visors. And almost fell to this blunder, luckily it was dry.

 

Finally added my rear vinyl...Etsy...forgot where I purchased it from...had them cut down a larger piece as I wanted a more sleek stripe verse larger one going over the wheel well.

 

I was reading some reviews on Amazon on that, so many said it was junk but still tempted to order it

 

Installed the Toyota OEM Remote Tailgate Lock kit on Saturday, and fixed perhaps my biggest annoyance with the truck. I like the peace-of-mind knowing that when the truck is locked, so is the tailgate...and in combination with the tonneau cover, anything in the bed is relatively secure.

Of course, my daily step count is probably going to decrease drastically. Every time I would get something out of the bed, I would lock the tailgate with the key, then get 50-100ft away and my brain would begin questioning whether or not I actually locked the tailgate. So I'd have to go back to verify, even though I knew I locked it. First world problems.

 

IMO, any obvious physical deterrent will prevent thefts of opportunity. This product would be a good example of one. Installing a tonneau cover and tailgate lock would be another.
This is a also good reason to have a security camera overlooking ones driveway. The one I installed at my daughter's house engages a big LED flood light when motion is detected. Most thieves would keep walking to look for their next possible victim when flooded with daylight knowing their actions are being recorded.

 

What is the part # for the OEM Lock from Toyota?

 

I have the AVS in channel as well great visor and low profile,..

Downside of the in-channel vs on body type visor is the wait time for the 3M tape to cure.
Its that fine print that reads "allow 72 hours to adhere" to the rubber.

They did roll up and down fine after the install, but the window will grab the forward lower visors edge if the tape has not cured.
After the 3 days they stick just fine.

 

There are 2 different part numbers, depending on your configuration. For my 2022 TRD OR DCSB, I can confirm the following part works...

Part No. PK3B635JS0
https://parts.toyota.com/p/91139371/PK3B635JS0.html


There is also this part, which I believe is for long bed Tacomas...

Part No. PK3B635JL0
https://parts.toyota.com/p/91139370/PK3B635JL0.html

 

Nice I used an earth magnet for my chain to stop moving around.,

 

Where did you get the Topo graph letters?