Break override malfunction

I have 17 trd or I had a blown fuse and i replaced it now it just turns over and want start

 

We need more info, what fuse? why did it blow? what were you doing before it blew? how many miles? what mods?

 

It was the 10a stop fuse that was under the hood, I was just driving down the road when I Noticed that I had a break override malfunction light on. So I turned the vehicle off and then it would not even try to turn over so then I found that the 10A stop fuse was blown so I replaced it and now it just turns over but will not start where before it wouldn’t even turn over with the blown one.. i have led taillights

 

Without any more information than we have at hand, I'd be looking for a second blown fuse. At the end of the day you're going to need to find out what caused the fuse(s) to blow in the first place. No one can tell you that with the information, or lack thereof here.

 

How long ago did you do a DIY mod like LED taillights?

 

There you go. LED taillights the culprit . There may be other fuses involved . This is a screenshot from tha MAN himself explaining why it happens with some led taillights.

 

I replaced the taillights about 5 months ago everything has been fine till yesterday

 

This just happened to me as well. Dealer blamed the third brake light on my camper shell. Seriously stupid.

 

That's typically how things break when they go... It's great.... until it's not.

 

This make me nervous with my total tail v2 installed.

 

This was actually me that had the issue.
Just replace the 10A fuse, and push down on ALL your fuses. The fuses on my truck in the engine bay were actually not all seated properly from factory.
I have the total tails from Meso and since I replaced the fuse and made sure everything was seated properly, never had an issue again.

 

After I replaced the 10a fuse it just turns over but won’t crank

 

To be clear the truck cranks (the starter turns the engine over), but the engine will not start?

Is the CEL on? Is the security 'key' light on? Do you have access to a scan tool to check for codes?

 

Hard to say what happened to your truck, maybe check all your fuses? Sounds like something else might have blown. Disconnect the battery while checking and replacing the fuses in the cab and bay.

Wish I could help you ID exactly what is wrong but im just here behind a computer and not in front of your truck.

 

Yes that’s correct the starter is turning the Motor but will not crank. I have a video but it it want let me upload it

 

For ease of future discussions, 'cranking' is normally used to refer to the action of the starter-motor turning over the engine; the way your post reads, it sounds like the starter-motor is turning but the engine is not, as opposed to the engine turning, but not igniting.

 

Did it blow a fuse?

 

Oh damn he is an ARFCOMer. Didn’t notice that before.

 

Me too! I just installed the total tail stage 1 kit about 2 weeks ago. Everything went great and didn't even need resistors. This is the first time I've read of an issue like this, but the OP replaced the entire tail light with a non-Meso tail light, so I'm hoping I won't have the same issue down the road. OP I hope you are able to resolve your issue.

 

is that osceola?

good luck with finding out whats wrong