What Have You Done To Your 3rd Gen Today?

Cleaned him up and started packing for this weekends trip…

 

Do have to get a different flasher?

 

Looks great! I've been on the fence for a roof rack.

 

I added the resistors for the tail lights and the front signal lights but then I found out if you use the CANBUS type then the resistor is built into the LED housing.

 

Cleaned it up after a 4800 mile road trip last week and mounted up some sliders after work today.

 

SHARP!!

 

Three gens of taco, sadly not in order

 

The TYC brand available at RockAuto is what you are looking for.

 

One could argue that it is in order...of coolness.

 

With a creeping Rav4

 

Looks awesome!

 

Matt in the access cab and running boards have been the first things ive been able to do.

 

You have to start somewhere although once you start, you never finish. There are so many possibilities.

 

Used it as it's intended, hauling a load to the dump

 

Bakflip X4S arrived yesterday and I installed it early this morning while it was still somewhat cool outside. I used the thinner gasket on the front bed rail and the X4S sits almost perfectly flush. It's so nice to be able to utilize the bed and store stuff securely while running errands. I do notice the slight weight increase when driving, but it's worth it. Also, the rubber strips have flattened out nicely in the 108 degree heat.

Definitely one of my favorite mods so far along with the power tailgate lock.

Thank You Luke! @truckalter

 

I have been wanting to do this but hesitant for this reason. What did you use to remove the adhesive? I have read mixed feedback on using something like Goo-Off safely and not damaging the paint.

 

Finally got my TRD skid plate clone installed. What a PITA! You'd think it would be an easy job. I was figuring 45 minutes. Nope! I believe I was finally done in about 2 hours. This of you who have done this by yourself...kudos to you! I had a hell of a time getting the bolts to line up and thread in. I tried the floor jack method, still couldn't get it lined up and the bolts started. Fortunately, my dad just happen to stop by. With his help we got it done. Also, I think the plate was a little too flat (maybe during shipping), because I had to really flex the thing to get the rear bolts up. Oh well. It's there now. All torqued to spec. Hopefully I never have to take it off. If I do...I'm selling it because I'd rather buy something else that fits better. I also noticed that the plate slightly hits the bolt for the recovery hook on the passenger side. Not sure why.

 

I ordered a VFTuner kit and a YotaWerx tune.
Thanks @mZiggy looking forward to the gains!

 

You Cali guys and your showroom clean undercarriages are nutz.