Anti hyperflashing light bulbs

Hey, I have a 2020 SR5 tacoma and I'm looking for anti hyperflashing 7443 light bulbs resistor built-in, any recommendations, thanks

 

Lasfit seem to work well from what I've seen. I have a set of GTR's that don't hyperflash for sale but I think you have to have the higher trim with the led strips for them to work properly (I also have a set of those headlights for sale lol).

 

I used Lasfit for the amber front turns. I can't have the DRL's on or it hyperflashes but with them turned off the turn signals work fine. They are very bright.

$49 LASFIT 7443 LED Bulb CANBUS Ready 7444 T20 Turn Signal Light Front or Rear Blinker Anti Hyper Flash No Load Resistor Need Upgraded Intelligent Temperature Control Version Amber Yellow (2 Pack)

Amazon.com: LASFIT 7443 LED Bulb CANBUS Ready 7444 T20 Turn Signal Light Error Free Blinker Anti Hyper Flash, No Load Resistor Need, Upgraded Automotive Replacement Bulb- Amber Yellow (Pack of 2) : Automotive

 

What does it do when you have your headlights on?

 

They don't hyper flash with the headlights on either

 

Have you tried any of those in the rear turning lights?

 

I have all the Lastfit bulbs in the rear and no issues. But I also have the factory led fronts.

 

I guess that if your truck came with some LED bulbs, it means that your truck already has the design to hold led bulbs w/o hyperflashing

 

Meso Total Tail Stage 1 is what you want. Don't waste your time on just doing an led swap in the back.

 

I agree! I just went the cheap route for now since I already had the bulbs from a previous vehicle.

 

Could u tell what that is? A kind of bulb? A system?

 

The Total Tail? One of the coolest little tweaks on the market for the 3g. Fully pnp.

Total Tail Stage 1 – MESO CUSTOMS LLC

 

^

X2

even though I have stage 2 but I don’t see those coming back again due to the price of those bulbs. But you can upgrade the bulbs if desired and want to drill your tail lights

 

Well, I've made a research about the tail stage 1 and it looks good but for 150 bucks still needs a resistor which make me think if I can save a lot with a regular led bulbs with external resistors?

 

I bought these from eBay - plug and play. $300
Fit 2016 2017 2018 Toyota Tacoma PRO-Series Red Smoke LED Tail Lights | eBay

 

I have the Meso stage 1 tails in my '19 SR5 without the resistors and have no hyperflashing. I highly recommend them.

 

This might sound like stupid comment but have u tried turning lights while headlights on?? I've seen literally over 30 videos , some have problems and some don't with stage 1, reason?!! Don't know but it's happened.

 

Same for my 2021 Sport. I even ordered the resistors with the Stage 1 kit so I had them in case I needed them, but they didn't hyperflash at all. I did the install by myself so when I finished with each side I laid the tail light on the tail gate, turned on the video camera on my phone, started the truck and tried every light combination I could think of, then watched the video before re-installing each side. Guaranteed if I hadn't ordered the resistors with the kit it would have hyperflashed

 

Assuming you are asking me, yes I have used the turn signal both with and without headlights and it makes no difference. Why some have problems I can't say.