Kenda Klevers 265/70r17

So I have a question I can't find anything about. I'm running Kenda Klevers R/T in 265/70r17 at 55psi.. if anyone is running them am I too low or should I run them at a Higher PSI? Max is 80. Many thanks.

 

Dude that's way too high. Should be closer to 30.

 

Edit: You're probably getting excellet gas mileage, but you'll wear out the center of the tread real fast. Not to mention the reduced contact area and rough ride. As said, try 30-35 psi. Ideally, you should perform a chalk test.

 

I would start at 36 psi front and 33 psi rear

 

Even if they are LT's and E rated? I'll bring it down I suppose

 

Does your truck weigh 8k+ plus like E-loads are ment for?

If not then you really need to drop your pressure, your ass and passengers will thank you.

I run my E loads on my 6k lb truck at 33psi.

 

What mpg difference would I see?

 

E rated makes a difference. I did the chalk test on mine. The sweet spot was around 40 psi

 

Since you're already running heavy heavy E loads I suspect it wouldn't change much if it was noticeable at all.

 

What minimal you lose in MPG's will be saved in MPT's (miles per tire).