2TR burning oil like crazy

I noticed my engine had less oil in it than normal so i put some more in about a week ago and it's already low? There is so signs of leaks anywhere. I'm really hoping I don't have to replace gaskets and rings and stuff. Is there any reason it's doing this?

 

Either rings or valve stem seals typically. Might also be worth inspecting the PCV valve for proper function

 

You can also note i put an oil catch can in. But i see no oil in it at all and there's no oil anywhere.

 

Doesn't sound good. Does it smoke on startup, especially after 2-3 days sitting?

 

No it does not smoke is there anything else that could be causing it

 

That leaves the rings. A compression check can confirm that. But check that the PCV valve is not stuck closed - may be easier to replace it, they are not much $$. I replace mine every 100K.

 

Just ordered. how do i check if it's closed or not?

 

When you pull your old one out give it a shake. There is a little check ball that should make some noise, if it doesn't make any noise when shaking it most likely it is stuck. Also be careful when installing the new one since it is plastic on the 2tr, I broke one on my old truck by over tightening it

 

Bad news I broke it how do i get the thread out

 

How many miles?

 

207k

 

See this thread for worst case.

https://www.tacomaworld.com/threads/2tr-fe-oil-consumption-issues.574172/