Ac not working

Having a issue with my 2010 tacoma. Over the past week my AC/Heat has stopped blowing in my truck. I have checked all the fuses and replace the blower motor resistor as well as dropping the blower motor and testing it out and it was fine. Any idea what the issue could be?

 

https://parts.toyota.com/p/Toyota__...ir is coming out,a failed blend door actuator.

 

Thank you, another question if you don't mind if this is what's causing the issue would the defrost still be working that's is the only thing that is working at the moment.

 

So is it blowing air but not out the vents or is it not blowing at all?

 

It's not blowing out of the vents at all the only place that seems to be blowing is when I have the heat on and the defrost. Another than that it's not blowing from any vents.

 

A blend door problem can cause air flow from "wrong" vents, i.e. different than the control setting.

 

Alright thank you I will try that out.

 

The actuators can be seen by removing the glovebox and floor duct, the duct is a little tricky to get off but pretty easy once you figure it out.


The notch on the actuator shaft should line up with the mark on the actuator body as shown in the picture below.


Recirc door should also be open as shown with the recirc button on.

Closed (Recirc off)


Open (Recirc on)