Replaced evaporator now truck won’t stay running

Pulled dash and unplugged wiring from passenger side to driver’s side. Marked the plugs. Replaced evap and put everything back. Now when I try to start my truck it fires and stalls almost instantly. Been looking for anything I might have missed with the wiring but not finding anything. Any ideas would be greatly appreciated.

 

Welcome to TW!

 

Thanks
Figured I would give this a try. I usually just work on stuff until I figure it out myself. But I’m getting older and less nimble so being upside down under a dash has its limitations.

 

I did find this plug above the fuse box but I don’t think it goes anywhere.
I have the truck back together now. Just won’t stay running. Acts like it’s getting no fuel.

 

Welcome to TacomaWorld

 

Figured it out. After pulling the dash out again I found a plug I missed. Straight above the steering wheel all the way up neat the glass. Not sure what the module is but the truck will not stay running if it’s not plugged in.