Lifted TRD Pro

First I lifted both the front and rear of my 2020 TRD PRO with a Westcott Designs 2.5" kit 2.5" front and 2" rear.

Does anyone know what size Nitto Ridge Grappler or Nitto Terra Grappler. I can get to fit without rubbing? I'm thinking 285-70r16, let me know your thoughts, thanks in advance!

 

I have a 2020 OR model with a 2 1/2” lift and run 285/75/16’s. I rub slightly at full left lock.

 

You can run a 285 but not on the factory wheel w/o a spacer, it will rub the uca. And depending on what alignment specs you run maybe some slight rubbing on cab mount and mud flaps.

 

What spacers do you all recommend?

 

I ran spider trax until I found out they are illegal in West Virginia. Ended up buy a set of Mickey Thompson rims with the needed backspacing.

 

i only see a 1.5 and 1 inch lift on westcott website. post link to 2.5 and 2.0 lift thanks

 

Spidertrax, Bora. Just remember when you add the spacer you change the scrub radius which can cause more rubbing. So if your dead set on 285s you made need to get ucas.

 

Hmmm... I just assumed he added the extra +1" that the Pro has versus other Tacos to the Westcott kit numbers. What say you, OP?

 

That's what I did was add the extra 1" for the TRD Pro, sorry, I should have stated that.

 

Its slightly different for everyone. I had 285/75/16’s and not a single rub until I added spacers. I did the cab mount and pinch weld and no rubbing. I did not rub on the UCA on neither the stock ones nor aftermarket. I then recently changed wheels with -25 offset and 295/70/17’s and now I rub in the front. You may not rub at all without spacers and they should sit flush to the fender trim if you have stock wheels.

 

So did you add the spidertrax spacer and then it started to rub?

 

Upper control arm

 

Exactly. I actually just remembered it rubbed on the sway bar a little before spacers but that was all. Spacers made it rub on the cab mount.