SOLD DIY Tacoma Anchored Half Bed Slide- One LEFT- Northern CA Pick Up. SOLD

One SOLD one left

I was toying around with making a product for a while and these are two prototypes that I tested. One has a single anchor in the back and the other has two anchors. I call them anchored slides because the rear has a T-nut that slides in a C channel that you anchor to the bed of your truck. It literally slides plastic on plastic and enables you to use the full length of the driver side of the truck. The bottom of each slide has been routed to match the bed bolts and such for easier use. It allows me to put a 75L Dometic fridge under my diamond back cover. In all you only lose about a 1/4” or so of height from the bed of the truck.

These would be for local pick up only in Livermore California. I’m moving in two weeks out of state and then they are gone.

The type of C channel needed- POWERTEC 71118 Double-Cut Profile Universal T-Track with Predrilled Mounting Holes(2-Pack), 24"

$18 POWERTEC 71118 Double-Cut Profile Universal T-Track with Predrilled Mounting Holes(2-Pack), 24"

https://www.amazon.com/dp/B074MN2CPL

They are 59” long, 20” wide, half of a short bed Tacoma, drivers side. They are extruded aluminum, stainless steel bolts, and HDPE.

This slide has a lock if desired and uses a single anchor point - $50




This Slide uses 2 anchor points

 

One slide sold one left

 

Bump

 

How much do you think it’d be to ship to 91302? Id totally take this

 

It just sold as someone just came to pick it up