What Have You Done To Your 3rd Gen Today?

Added some chrome delete in Army Green from Meso Customs and Dessert Does It seat Jackers.


Seat Jackers

https://desertdoesit.com/collection...a-1-1-4-front-seat-spacer-lifts-front-of-seat


AC rings

https://mesocustoms.com/collections/toyota-tacoma-3rd-gen/products/vent-ring-kit








Interior Chrome Delete (gear shift and 4WD)

 

I see you have the 4Runner SEMA wheels, but do you have wheel spacers also? The back look like they’re out an inch or two past the fender

 

Desert. But a fuck ton of members are down with the DQ.....

.

 

cold idle - mild
warm idle - quiet
cruise (low speed, no load) - mild.
acceleration (under load) - It is a straight through muffler, it's not race car loud, but louder than I expected - this is where it makes the most difference.

The sound is clean, no backfiring or pops on decel.

I haven't had a chance to test the drone limits yet. Only been able to get up to 60-65 @ 2k RPM in 6th gear (manual). At this spot, no droning while cruising. The real test will be at a 70-75 mph cruise @ > 2500 RPM. I imagine there will be some and will find out eventually if tolerable.

I tried to get some iphone recordings but it is not very good. I can't get any better video on the sound than what you can already find on Youtube or Magnaflow's site.

 

Hey I know it's been almost two years since you did this but I just received mine and it's missing two pieces and has no instructions. Did yours receive instructions? I think I can figure it out based on your photos and their photos on Instagram though. My big question is if you stuck any on the plastic door panels or if everything goes on the metal either inside the door or on the outside like we see in your photos? OH! and did you have to redo the glue stuff on the vapor barrier or was it still sticky? If so, what glue did you use?

Thanks!

 

Took a road trip for some hadawgs

 

Did some truck stuff...hauled custom furniture 500+ miles

 

reason ?
how it sound now?

 

what size are those KM3's and how are they so far? Heavy?

 

what about the sun visor screws?

 

I think I might order a set now that I know the logo can be removed.

 

Nothing too exciting today. Oil change and tire/spare psi check. Really racking up the miles on the 2017.

 

Installed Wheeler's front superbumps today.

Comparison between wheelers and stock.


Before:

After:


Have a set for the rear, and 5125s. Waiting for my Icon RXTs then I'll install the rear setup!

Can't wait..

 

If you know, you know

 

Bumper is a Scorpion brand from Bumper Superstore. Seems to be pretty sturdy and didn’t require cutting the factory bumper. Winch is some Amazon special that I had on my last truck. Hasn’t been used a ton, but has always worked well when needed. I think Rugcel is the brand, 13,500 pound with synthetic line.

 

Installed TRD intake…pretty straightforward.

 

Sold that B. Didn’t need a payment or a truck really. Plus just didn’t like it that much. Nothing wrong with it at all just didn’t really ever click with me