What Have You Done To Your 2nd Gen Tacoma Today?

I got mine from hooke road

 

wheres all that molle stuff from?

 

What molle panel are you using. thinking of doing this set up. so sick.

 

@Brian422 and @Danieldee. The rear window is the rago fabrication 3rd Gen tacoma panel and the shelf is for the 5th Gen 4 runner. Both required minor modifications to fit my 2nd Gen. The over head is mesocustoms original MOLLE roof panel

 

Yeah kind of cheesy and certainly not very exciting but someday it's the little things in life

 

Had my trac and ABS lights come on about a month ago, figured it was a stretched wire from my lift. Took it to the stealership to pull codes and they found 4 codes. Open or short in both front end wires, bad ABS sensor driver side, and a steering column sensor that they thought was weird. Charged me 85$ to hook it to the scanner and read out codes.

Decided I should just invest in a better obd scanner that pulls ABS instead of giving it to a stealership again so I ordered a scanner that does ABS, a new ABS driver side sensor, and 2 new front ABS wires. Replaced the ABS wires, broke 2 bolts I need to remove now, and pulled codes myself. it was still reading all 4 codes. Didnt realize I could clear codes so after reading the manual I cleared the codes drove it for 2 days ABS and TRAC never went away. Pulled codes again and only ABS and Steering codes this time. Finally got around to pulling the ABS sensor and what do ya know o-ring is split open and its all gunky. I must have accidentally sprayed PB blaster near the sensor and it ate the o-ring letting junk and moisture inside. Popped the new sensor in and cleared codes and the lights went away this time and the codes didn't come back.
Now I just need to fix the blower motor wiring and resistor and she's back to a good state

 

Throw hate much?

 

My Archive Garage Hangers and cross tube arrived as well as my front/rear/Ubolt kit by Durobumps that I got through Poly Performance. Now to find time to install everything.

 

I thought it was rago stuff mismatched but wasnt sure lol

 

Used the splash guard thread to make a new set:






And wrapped the B pillars in satin black. Not bad for never having vinyl wrapped before.

 

Part number for the wire and the sensors?

 

What scanner did you wind up with ??

 

Today I popped a brand new CV boot/axle in the process of replacing an original tie rod end. Gotta love re-work

 

Had my hood and that small leading edge of the front fenders painted this week. Picked it up today. Had a bunch of rock chips from an incident with a UTV. My comp insurance covered the repair ($100 deductible). I bought and had them install some new OEM headlights as mine suffered from the DTRL cracking/melting issue. They did a great job.

 

Joined the Softopper gang today

 

Hit 60,000 miles on my way into town today. About 9,000 of ownership
cue the another 60,000 and she'll be broken in

 

Can you post a pic of the whole truck? Been thinking about doing this to mine!

 

Any more info on the homemade splash guards? Those look pretty good!

 

Took it to my local (90 minutes each way) Krown applier for rust proofing. Gotta take care of this so that I can get to 300,000 maybe even 500,000 miles!

 

When I installed mine I torqued it to whatever specification was listed on the package, I can’t remember what it was, but if it says 12, go with 12. Just check for leaks for a couple days, which is much easier than replacing the lower oil pan because it’s stripped.