1/4" Toytec top plate spacer (provides 1/2" lift) for taco lean

NO LONGER FOR SALE!!!
Brand new, never been installed Toytec 1/4" Top Plate Spacer for sale that will give you 1/2" lift up front. I bought this to fix the taco lean, but decided not to install it.

I know it will fit 2005-2010 Tacoma's (except 5 luggers) but I think it will also fit the models below, beacuse I see that the part number is the same.

Part number is TP-14

Toyota: FJ Cruiser 2007 - 2010
Toyota: Sequoia 2001 - 2007
Toyota: Tacoma 2001 - 2004
Toyota: Tacoma (pre-01) 1995 - 2000

NO LONGER FOR SALE

Let me know if you have any questions.

Thanks.

 

I am a little slow when it comes to suspension and for trucks, but if I order bilstein 5100's pre-load adjustable front and rear will I still need this spacer to stop my truck from leaning? And will this spacer work with any suspension set-up?

 

Only if your truck leans after the lift. So lift it then see if you need it.

 

as S.B. noted, you will only need it if you have taco lean (truck leans to drivers side due to weight of gas tank, battery, driver, etc). However, if you have the lean before you install bilsteins, you will also have the lean after you install them.

And yes, as far as I know, it should work with all suspension setups (except for the 5 lug trucks).

Hope that helps.

 

Most people just preload the right coilover to accomodate for the lean.

 

Must be nice to have adjustable coilovers

This spacer is very common for folks who run 5100's or an OME setup.

It will work with any suspension setup, stock or aftermarket.

 

Thanks KPT. I edited my post to reflect that.

 

Just use U.S. Post Office Flat rate envelope to ship it anywhere in US Priority Mail for $4.95

 

that's why i have the price set at $25. (20 for the part + 5 to ship).

I was saying I didn't know why TOYTEC charged $11 to ship.

 

I have a set of them too I actually forgot to install them when i did my lift, not enough of a lean for me to want to go in and put them on.

 

i can't for the life of me figure out how to lock/close this thread. searched all the stickys and instructions, etc. anybody want to help me out?