RSi SmartCap (Photo Heavy)

Me either. I’ll still use marine lubrication and avoid snow storms in Florida. We just had low 20’s last week, so not so funny anymore!

 

pfft. around here, we call that "Spring."

 

My truck spends half a year in Maine, but in summer-like conditions. If the red squirrels figure out the latches I may install the weather guards.

 

I wanted to add a rack so decided to go with the same as the cab, its not level but I haven't had any issues with the occasional lumber or items from the hardware store......

 

Can anyone please tell me what bolt size fits these threaded inserts inside the cap on the roof? Thank you!

 

M8 x 10mm

I put these in mine:

$8 SamIdea(TM) 5-Pack M8 Stainless Steel Shoulder Lifting Eye Bolt Ring with Male Thread

https://www.amazon.com/dp/B06XK8168Z

 

thank you!

 

Thats a good idea. I ordered some and will figure out something to hang

 

I have Quickfists attached there for my murder spork and also store my jack foot plate there.

 

Dig that set up, what molle panels and propane tank mount? Been struggling with how to set up everything to best suit my needs.

 

The sidewall mounted MOLLE is from Cali Raised LED, the 5lb propane tank holder is from All-Pro Off-Road's Overland. Additionally, to the left of the propane tank mount is a modified

$42 Allstar Performance Battery Tray, Lightweight, 12 in Length x 7.25 in Wide, Frame Hooks, Hardware Included, Steel, Natural, Kit

battery mounting box that I use to hold my Jackery 500 that provides my off grid power requirements for my ICECO VLPro75D fridge.

 

Mounted my recovery boards to roof inserts over the weekend.

Here are the mounts I used. I got very lucky with the spacing on the mounts and the spacing of the threaded inserts where I was able to get everything lined up pretty easily.
https://www.jwoffroad.com/products/universal-traction-board-mount

 

I'm always concerned about putting anything high up that could become a projectile in a crash and come through the back window. Your shovel and hatchet make me nervous.

 

Nice find. I was going to make something but this will make the project much easier.

 

Good points. Not changing my setup, but I get it.

 

Have a picture of mounting brackets with out boards?

 

can two people lift this onto the truck after assembly?

 

I think 2 guys could but I wouldn't risk a dent or scratch.

 

I recall the cap weighing approx. 188 lbs for the EvoA. Three peeps you trust with your truck and a promise of free drinks usually makes this go better.

 

yes, but I strongly suggest 3 for maneuvering the cap. You don’t want to drag the gasket around the bed caps.