Trac control flash in curves

I had aftermarket wheels and tires installed along with a alignment, after that was done if I go in to a curve my trac light will flash and I hear a noise which a presume is abs but it doesn't do it all the time and I done a zero point calibration and replaced right side wheel bearing and it still does it,any ideas?

 

Go slower around corners.

 

Welcome To TW.....

 

You've got a pseudo LSD in the Sport. The brake will pulse on one wheel around corners like you are seeing. Sounds normal.

Elaborate on "go into a curve". Are you driving at highway speeds into a curve and it's doing this? Or are you drifting around 90 degree intersections?

 

No I'm on backroads going about 30 mph it did not do this until I changed the wheels and tires and done the alignment

 

If the ABS is activating its sensing a wheel slipping

 

Probably need to recalibrate VSC. It’s a good idea to do this after an alignment

https://www.tacomaworld.com/threads...ibrate-your-vsc-computer-the-easy-way.467485/

 

Tire isn't slipping roads are dry and I did a vsc recalibration but still does it

 

What kind of wheel bearing did you use..Toyota Calibrated it?

 

TRQ bearing and I calibrated it myself

 

Can you read wheel speed sensors with your tester?Not saying thats whats wrong with yours ,but i have seen some encoders smudged on some bearings and cause that issue...

 

The wheel speed sensors were checked and said they were good

 

Welcome, perhaps have a shop give it a try.