What Have You Done To Your 3rd Gen Today?

I need one.

 

I just got the red and the blue one today!

 

I have just received the following from AliExpress:
P22 Dual System HUD With Overspeed Low Voltage Alarm Head Up Display Speedometer Slope Tilt Meter OBD2 GPS Car Electronics
https://www.aliexpress.us/item/3256...00030933025084!sea&curPageLogUid=xFeFkWdwXcHl

Good lord, the U.I. is a PITA. However it starts up pretty quick, and it apparently does retain the last screen it was on when you turn the truck off.
I'm having a little problem with the 12 variable screen, getting things laid out how I want them and in the preferred units.
I have not found a way to display Oil Temp, Coolant Temp, nor Transmission Temp.
The manual is horrendous.
For those that don't want to buy on AliExpress, it can be had on ebay for a bit more.

 

Cool. And the maintenance on those little guys costs next to nothing.

 

Just a choking hazard

 

But a PIA to make accessories and Mod.

Now you tell me.

 

I had to deal with thunder sleet today - blew past those 2wd peasants on the steep hills

 

So far, I’ve got these things done:
- removed the winch mount bumper
- removed the actual bumper/grill
- removed the foglights
- installed fog lights to arb (took some drilling)
- installed the winch and fairlead

can’t figure out the turn signal install - the hardware provided doesn’t make any gotdamn sense.

will bring to install the mounting kit to the truck tomorrow, and finally get the hoist mounted in my carport so I can lift the bumper into place. Thennnnnn it will come down to the rock sliders and side rails. Lots to do.

 

That things a beast! Can't wait to see the end result.

 

Got my @upTOPoverland rack and went straight to work on it
And yes, it clears lol

 

@alwaysHI
Mean set up! And perfect fit for both the rack and garage!

 

Small mod, but I finally swapped out the original shift knob for a TRD rep. It doesn't say TRD on the back plate, but it was also only $32.

 

I overthought my method for sure. Haha. I used one of those old school Bic pens and took the ink tip and end cap off (so it's just the white straw-like tube), inserted the tube through the loops on the bag, and secured a long zip tie through the tube and around the loops.

Some people use a long skinny bolt, or a pencil and tape, or even just a zip tie....doesn't matter all that much. It just needs something to keep the loops from pulling out once the console is snapped into place.

 

How does the quality of these reps look and feel?

 

How much will the finished bumper weigh?

 

Approaching probably 225 lbsor more

 

170# w/o winch

 

I just installed mine last Sunday. Real cool. The only down side, they effect my f.m. radio when they are on.

 

With winch, ~250lbs

 

What lift are you running? Looks great