A/C blower plug burnt

Need some help figuring out what is causing the power supply to my a/c blower to get hot.

 

It’s a known issue. They have made a plug and harness replacement. Let me see if I can dig up the kit part#.

 

That would be great. Thank you

 

Also check where the harness plugs into the resistor and sometimes even the at the ac control it will get charred.

 

Part #s are in link below.
You can thank @Dm93

https://www.tacomaworld.com/threads/2nd-gen-information-diagnostics.784008/#post-28042158

 

That's for the resistor and pigtail, I don't have a number for the blower pigtail.
Worst case you can just note which wire goes where and crimp some spade terminals on the ends and plug them onto the motor leads.
Probably time for a blower motor as well.

 

Yeah, I didn’t pay attention.
The blower plug is a 2 pin.

The ones on Amazon are NOT the same wire size.
There’s been multiple people buy them and report the wire gauge is smaller.
Most guys put them on anyways, but I don’t like going down in wire size.

 

This is a big help. Thank You!!