What Have You Done To Your 3rd Gen Today?

From their website : Incompatible Bottles:
Yeti Rambler 36oz and 46oz.

 

We hit 10psi and she HAULS OUT! But we will keep it to around 7psi.

 

I didn't realize this was a problem until I tried to put random water bottles in. Just ordered a Z precision cup holder.

 

ugh, I'm titillated... excited to see more!! Good form, sir.

 

Bilstein 6112/5160 with an alignment and H9 low beam swap.

 

which setting did you go with?

 

adding meth? can't wait to see dyno #s.

 

It looks like you even got it color matched!

 

10/8 which is roughly 5/4 on the pre September Bilsteins.

 

I dont think there is a need. We had enough fuel around 9-10psi to make plenty of power. Remember, those Superchargers out there are sapping about 75hp from the motor which in this turbo case actually gets put to the pavement. I think on 6psi this will make more power than a Magnuson kit on 8psi. And on 9psi this thing is going to be wild. We need to do further tuning then we will release a dyno with some good pictures also.

Oh and the sounds this thing makes...

 

Replaced it with a new one lol………kidding……been a few years and a couple vehicles later but finally got back into a taco…..I’m glad I did.

IG: oldmanyago8541

 

Awesome! Is that an MT by any chance? The sounds from the blow off valve during shifts brings a grin every time. Really makes me miss my hobby car sometimes but needed room in the garage for the Taco.

 

degreased my husky liners and vacuumed the carpet floor

 

Link to sound?

 

What kind of fuel management are you testing with the kit?

 

Possibly, right now I'd consider these beta.

 

It is an AT. However, the BOV hits so hard you hear it with every gear change!

This is all being worked on. Will release videos soon. Its not even just the BOV. The turbo spool is exhilarating.

We are using VF tuner.

 

would that mean the end user would just need top flash a baseline map to run X amount of PSI out of the box?

 

Not today but the past couple weeks...

Accutune 4A suspension


Method 703 Gloss Titanium wrapped in 295/70/17 Mickey Thompson Baja Boss AT



C4 hybrid bumper with 30' DD lightbar and TravellerX 10k winch


Then a nice foamy wash down last night....

 

We are still testing that but in a low boost setting like 5 or 6 psi then most likely. However when you start pushing higher psi like 8 or 9 then a feedback tune would probably be required. But this can all be done remotely by just datalogging and emailing files.