Driveshaft Hardware Size

All,
I have a 2008 long bed, double cab, 4wd,
with a 6" lift taco. I'm looking to clean up the threads on the transfer case output flange studs (where the rear driveshaft connects to the transfer case). I would like to buy a die to run it on these threads but I have no idea what size and pitch. I took the nut to a couple of places to no avail. These places were probably not the best choice for this but they were very convenient at the time. Does any one know what size and pitch these studs are?

 

I think it might be a M11-1.0 thread size...but I'm only willing to wager about $.03 on that bet, so hopefully somebody else can back me up here.

 

I’d say you are right
https://lowrangeoffroad.com/drive-shaft-nut-11mm-1-0x30mm-tacoma-05.html

 

Well then, my $.03 is all in...

 

Thanks all for your thorough input and most of all some humor along the way. Have a great weekend and Keep on Truckin.

 

I ran the die & it all went swimmingly well.