What Have You Done To Your 3rd Gen Today?

Check out Fitztaprint on Etsy - solid seller with all sorts of different panel configurations!

 

Trying to fit a 275/70/17 spare under the truck. It's pretty snug here now but I'm worried that I can't get it all the way up in the spare wheel well. Do ya'll think this is an issue? I tried hammering out the two clamps but they didn't budge much. Thinking of grabbing a torch to ease the metal up a bit and having another go at it.

 

Deflate the tire some or completely (if you have a compressor onboard). And pull it back towards the hitch while you bring it up

 

Finally got the Pro Shift Knob Illumination installed, and I love it.
I also tied it into the security light as you can see from the pictures (blue for interior and red for the security).
I tied the blue interior LED to be on when I have my headlights on. I installed LEDs in the cup holders and rear center console so it was easy to just tape into that wiring.
Not sure what the difference is between the AT and MT but I did not have to drill a hole in the collar to pass the wires through.

 

Finally got around to mounting the traction boards properly prior to upcoming shenanigans at the Outer Banks.

 

I used a 27oz dead blow hammer and they moved significantly with less than 10 whacks each. Pulling the spare rearward while lifting as mentioned above also helps.
This is what my 285/70r17 looks like fully inflated:
Edit: this is also with the lifter relocate linked several posts below

 

I have a KO2 spare in that size. The tire shop couldn’t get it to fit but I just got under the truck and shimmied it side to side while essentially bench pressing it and got it to squeak into the spot. I probably bent something in the process but it fits.

 

I opened my tailgate.

My office chair hydraulic piston is entering a failing stage after 3 years. I considered swapping the Taco stock OR shocks for 51xx/61xx and use the original as a chair system, but I figured you would say they are not enough.

So bought a new office chair instead ... Tempurpedic seatpad which is very comfortable so I just bought another one of the same model.

Just a bit easier than transporting in a Corolla.

 

I installed the Hypertech speedometer calibrator. It corrected the difference caused by the 33” tires I installed as advertised.

 

Strip it off completely, prepare the surface (it needs to be slightly rough to allow for good paint adhesion) then spare no expense on the primer and paint you choose, it really does make a difference. Seek advice from the paint representative of the brand of your choosing (Sherwin Williams for example) and they can easily offer you the best solution for your material and environment.

 

Got the new truck out on the trail for the first time. Had a blast

 

get it down to metal. wipe it down with isopropyl or mineral spirits. Use an etching primer. sand. primer. sand. paint. sand. paint. etc..

 

Good looking rig!

Where are those trails?

 

Thanks! It’s Citrus Wildlife Management Area in Florida

 

Super sharp!

 

Hi-Lift Lift-Mate is finally here. I’ll test it out and post pics next weekend. Way too much going at work this week, won’t have the energy or patience after work this week. It does fit nicely in the wheel spokes though.

 

Seeing if I need the back up light glare reducer. Technically it’s gorilla tape. And blocking 1/2 the backup light slot does reduce the glare when I reverse.

 

you got a link to those cup holder side storage things?

 

What size tires? Diggin’ the viper cut.

 

Oh man I’m jealous. I was supposed to go to Citrus today with some friends but I spent the past day and a half in bed instead.