What Have You Done To Your 3rd Gen Today?

@OffCamberCurve

That's near the Sporting venue complex...I've been to Wells Fargo Center when the NHL Kings came to town before Covid.

I also took my youngest to Citizens Bank way back in 2010 when the Dodgers visited.

I'll have to try Old Original Nick's...it's closer than Delassandro's. Hahaha!

My buddy (who's from Philly) will have something to say about Old Original Nick's...lol!

 

Finished modeling and printing a left side switch panel for more OEM style switches so I could build out more additions in the future.

I'm going to at some point make a post in the for sale forums down the road when I stop being lazy (maybe ~$60ish for the panel seems reasonable maybe?). Printed in ASA @ 260°c+ a high temp/UV resistant material and UV. Open to PM's if people are interested too.

 

Stuff from the past few months:

Method 703s 16x8
Moved tires up to a 285/75r16 from a 265/75r16
Alu-Cab canopy
Front Runner racks
Nitro 5.29s
AlphaRex NOVA headlights (not a mod I usually would care about, but my OEM ones were getting sun faded and I wanted to ditch the HID kit to get rid of those extra components)
C4 front and rear bumpers are on order and should be on in the next couple months.

 

Your truck looks great!

What ceramic coating did you use?

 

They are Cali Raised LED Step Edition Rock Sliders.

https://caliraisedled.com/products/2005-2021-tacoma-step-edition-rock-sliders

 

Thanks. I’ve been liking hyperclean DOS. And then washing w snow after

 

So you are planning to fund the retirement at age 35 for your cardiologist?

 

+1

 

No going back now

 

GAS cap holder?

 

The driver side hanger looks so weak in comparison.

 

Agreed

 

Oh not too much, just basically gutted the stock suspension, save the knuckles and LCA's.



Bilstien 5100's up front
887 springs from OME
JBA high caster UCA's
Green lane 0.25" strut spacers, diff drop, sway bar relocate
ECGS diff bushing upgrade

Bilstien 5100's rear
Dobinsons medium load lifted leafs
Archive Garage U-bolt flip kit and bumps
2.5* pinion shim
3/8" carrier bearing drop.

Was a real treat working on a vehicle that has only been on the road for 2 years and under 45k km's. Not a difficult bolt to be found.

So far so good for vibes, clunks, whines, etc


No front end shot as I still have the OK Expedition skids off till I get an alignment and re-torque and mark everything.

 

Upgraded dashcam.

 

Boot slide

 

Went from this,



to this.


Both sides

 

Confirmed it was Forward Patch Control that made the Spooky Patch. However They're no longer being made as it's no longer on their website.

 

I would wrap the exhaust pipe in that region near the tire with some heat reflecting tape.

 

Finished my "homemade" molle panel

 

A local-to-Phoenix outfitter shop (SDHQ) sells a wrap-around gold-reflective sheet, I think they said $60.