Are these jackstands high enough?

Got a 2023 sr 4x4 coming this week and going to paint the steelies. Are these jackstands high enough to take all 4 wheels off?

https://www.walmart.com/ip/Hyper-To...Ql_T9xSPj--IcRWjpMhoCEtYQAvD_BwE&gclsrc=aw.ds

 

nope, buy the $35 one in the same page it might be high enough , just dont get crushed

 

also i might add 2 ton jack only holds 4000lbs i believe the 3rd gen weighs 4500lbs , i wouldnt cheap out just get the $80 jack

 

I got these 6 ton jacks. Some jacks are rated per pair...keep that in mind. They're a little pricey but they're US made and built to last and give me a sense of reassurance getting under them.

https://www.usjack.com/products/garage-jack-stands

 

Those were jack stands (good idea).
I’d spend some money, cheap is NOT where you want to be

 

I would get those ones personally.

 

They are fine for supporting the axle or control arms. I think these would even reach the frame.

3 tons is better, no jack ever supports the entire weight of the truck, but you need overhead.

 

Spend a little more coin and get some heavier duty ones. Isn't your noggin worth a little more ? If you are planning to use all 4 on an asphalt drive way, consider putting paver stone under in case one sinks and truck fall off while you are painting your wheels.