What Have You Done To Your 3rd Gen Today?

Interior is next on my chrome delete list, debating on buy or paint....leaning towards paint

 

little more effort, little less money

 

Soak in bleach, clean, and paint OR scuff, clean, prime, and paint?
Seems 6 one way, half dozen the other

 

yeah, seen some people just wet sand, primer and paint. Several different methods to go about it though

 

Haven't purchased it yet, but this is my next interior mod that will be done. I'm tired of my 32 and 40oz water bottles rolling around. A must have upgraded.

 

I have these installed. Super easy install. Worth every penny.

 

I just ordered the same one a couple of days ago. Should arive any day now. It'll be nice to not have my Nalgene bouncing around all over.

 

OOF

 

I've been looking for a solution to the water bottle problem, was even going to as far as getting a chalk bag for climbing and put a long bolt threw it and install it on the driver's side center console. This is the solution I've been looking for.

 

These fit pretty good in the bottom so you don’t have any rattling:

$10 TOSSOW Silicone Coasters for Drinks with Holder Set of 6pcs Black, Non-Slip Heat Resistant Thick Insulation Durable Coffee Drinks Coaster Set Wine Cup Mat

https://www.amazon.com/dp/B07D4CHJD6

 

Thanks for posting that. I think I'll have to follow your lead with this upgrade. I can't count the number of times my hydroflask has rolled off the passenger seat and on to the floor.

 

Yeah my hydro flask rolls everywhere, usually keep it laying down on top of the E Brake but that's even a pain I the A$$.

 

That's one of my biggest bitch's, no place to put a 32oz water bottle. I even tried to down size to a 20oz and that was a NO GO. I didn't want to buy one of those cup extenders cuz then it just raises the bottle even higher than it is. So my order will be placed once I get paid and one of my troubles will be gone for good. Cali Raised LED also makes one in case you wanted to check them out. I think they were asking upper $50's for theirs.

 

Just added that to my Amazon wish list. Thank you.

 

Amazing, ride honestly feels smoother and sharper but my tires were also bald as hell lol. You can notice the weight difference just a little bit since part of the sidewall is 3ply and its a slightly larger tire by almost an entire inch but doesnt effect performance. Road noise is exactly the same or just a smidge more. No complaints at all

 

Installed my new MX4 today.

 

Ordered a

$100 Noco GB40 : 1000A UltraSafe Jump Starter – 12V Lithium Battery Booster Pack, Portable Jump Box, Power Bank & Jumper Cables - for 6.0L Gas and 3.0L Diesel Engines

Noco GB40 boost and a set of x-act contour husky liners for the front and back. $25 rebate is available for the Husky liners until the end of the month.

 

Went ahead and ordered total chaos bed stiffeners too.

 

Wish I would have known about the VLEDS tailight conversion before I spent a grip on leds from Diode Dynamics.

 

Installed Cali Raised Led bed stiffeners.

 

Diode Dynamics hitch mount reverse light came in today also.

https://amzn.to/3D9XfoW

 

I went with the AJT version. Solid, works great and was a little more economical.

 

clean