What Have You Done To Your 3rd Gen Today?

Beautiful route!
Go leaf peeping on a weekday. Boreas will be bumper-to-bumper in the fall on weekends. Or ride your bike, but then you have to deal w/ all the impatient drivers.
Or take Leavenworth Creek Rd off of Guanella pass; the rocky/bumpy part at the beginning filters out all the pax cars, but is an 'easy' off-highway drive. Not as many aspen as Boreas but much quieter.

 

Thanks for the tips. I've been going up to Kenosha for a few years now. Been meaning to head up during the week and grab a dispersed camping site below the Kenosha campground, maybe this will be the year.

 

Just ordered the DS18's; im replacing tweeters again. This site is not helping me not spend money.

 

Thank you!

 

RUST? RUST? Whats that? I'm from Phoenix and needed to look it up in a dictionary. LOL

 

looks so good on the white. such a simple one but changes the appearance greatly imo. I have a 21 grill on my '18 it matches the mgm a lot better.

 

Silicone e-brake and shifter grip


DRL and sequential turn signal lights under the headlight


Midland mxt105 GMRS hardwired


Midland MXTA-26 and caliraised bed mount

 

Took it to the beach again, didn't have to use the bumper or winch, so they didn't let me down!

 

How are these in the rain & how good did they balance out?

 

Did a few runs thru Tail of the Dragon. I don't think any of the Miata guys suspected a thing

 

Which one is you?

 

lol…The truck is looking good as usual!

 

Finally got around to installing the Wheelers ubolt flip kit with 1" block on the rear.

Had installed 6112/5160s awhile ago on the 9/7 clips. Had a little bit of a lean back to it once everything settled in.

At the same time I installed the Bilsteins, I installed some Ride Rite airbags on it for trailering. Those damn brackets clamp the rear springs 2"-ish outside the axle (each side...so 4-ish total extra spread), which caused them to be harsh on big bumps.

So when I installed the ubolt flips, I made up little filler pieces so I could bolt the bags straight to the top plate. The load from the bags will now go on top of that plate.

Man, what difference! Buttery smooth with the stock leafs and no load. Any increase load I put on there I can compensate for with the airbags. Only ever really have the RTT and camping stuff, or the aluninum trailer with quads, so I should be good.

Will run this for awhile, and switch to RXT leafs if this doesn't work out.

 

23TRDPRO

 

I have got white and amber! Couldn’t figure out wiring so just put the amber wire attached, they are bright!

 

Before and After results! This product did a great job and it’s only $7

 

Installed the Backwoods Adventure Mods Hi-Lite front bumper today, pretty easy install took about 2 hours or so. Unfortunately, I can’t run my Diode Dynamic Ss3 that we’re mounted to the oem bumper so going to have to find some new pods ! Overall, I’m super stoked with how it looks and the ease of removal to add winch to the cradle , best part is I found it on market place for a deal I couldn’t refuse . And only 80lbs !!!

 

I just made the swap to DS18’s and instantly heard a big difference. Have Fosgate punch’s coming for the doors tomorrow. The DS18 are a great option over stock, plug and play 15 minutes.

 

Hitch Pod brake light install.