1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Pro Eagle Jack Mount Using Factory Bolt Locations

Discussion in 'Recovery' started by greenEFSI, Aug 10, 2023.

  1. Aug 10, 2023 at 7:24 AM
    #1
    greenEFSI

    greenEFSI [OP] TacoSupreme____

    Joined:
    Jun 29, 2016
    Member:
    #190830
    Messages:
    1,554
    Gender:
    Male
    First Name:
    Gio
    West Covina, SoCal
    Vehicle:
    '15 TRD Pro Super White
    I just wanted to throw this info out there since I haven't really found anything on TW. I was able to mount my pro eagle jack using the factory bolt locations. A quick trip to the hardware store and $5 later the whole thing was tightly secured.

    The front bolt works fine but the rear bolt is too short and needed to be longer. I drilled holes into the bed mat to allow washers to drop through it. That way everything was nice and tight when torqued down.

    Rear Bolt Spec:
    M12x1.25x120mm

    2.png

    3.jpg

    1.jpg

    https://youtu.be/J5NItQwmVKI
     

Products Discussed in

To Top