Non airbag buckets into a 2010 Reg cab

Metric grade 5 I think. I forget the size. I just took one of the others to the hardware store to compare

 

has anybody tried this swap on a 96 regular cab, im ready to chuck my bench ..

 

it wouls be so easy in a 96... just pull the seat out and find buckets to put in. you may need to shop for some brackets or make some...

 

Sure. It was a dollar for a pack of 10ohm resisters at radio shack. They didn't have any 3.3 ohm resisters. In fact, where are you going to find a single 3.3 ohm resistor.

 

Make sure they aren't 3.3kohms Because my radio shack had those.

 

3.3ohms

vs

3.3k or 3,300 ohms

big difference lol

 

Have you had any issues at all? I found a few off some 2005 to 2007's seats and really want to do this but really want the air bag sensor to work. If i took all the airbag stuff off my 2010 bench and put in on the 2007 seats do you think it will work or is there a issues i don't know of.

 

My write-up should answer all your questions, Especially check out part2 which goes into detail about swapping in the correct hardware with no bypassing at all!!

See signature below;

 

Thanks I will go back and re-read.

 

I just read thru these posts, but never found the write up you referred to. It sounds like it is useful info. My 08 doesn't have functional airbags since I put buckets into it. I'd greatly appreciate a little guidance.
Thanks,

 

I know this is a pretty old thread, but I am most of the way through such a swap now.
What did you do for the the U-shaped rail sensor on the drivers side from the bench seat?
It is a magnetic sensor that "sees" a piece of metal that passes through the U (but does not touch) when the bench seat is adjusted forward or backward. I have the complete harness from the bench in place with the buckets installed.

Thanks.

 

Recap on this topic, has anyone tried getting buckets out of a single cab?