2nd Gen Turn Signal Mirrors

I installed Turn Signal Mirrors on my 2012 TRD Off-Road. Motor to move mirrors work fine, I read that you need to run the wires if ur vehicle didn’t come with the turn signal mirrors, anyone know where to locate where to run the wires? Thanks

 

You need to splice into the turn signal circuit .

Without looking at The EWD or being in person I would be guessing.

 

This thread may help: https://www.tacomaworld.com/threads/diy-side-mirror-turn-signal.668265/

 

i have a taco with manual mirrors no power, or turn signals, if i just buy the oem mirrors will they bolt right on?

 

Bolt pattern is the same...

 

Yes they will bolt right on, but because your Tacoma did not come with power mirrors from factory, it might not have the right wiring harness to produce power to your mirrors. Let alone you probably don't have a switch to control the mirrors, so you would have to add a wire harness (could be a possibility that it is there) and control switch.

 

It did a lot, thank you very much!!!!!!!!!!!!!!