Fabtech lift with Spc Help

Hi I just bought a 2005 Tacoma with a 6 in Fabtech lift and I put Spcs on it and I’m constantly pulling cvs need help

 

Photos of your cv's at static height as well as photos of front suspension setup

 

IMG_5877.jpg

 

Put it back on the alignment rack and messed with the uca till it tucked the cv back in. But still nervous too off road

 

You sure you're lifted 6" upfront? That's the worst cv angles I've seen on a drop bracket kit. Factory axles? Aftermarket? Photo of the spacer ontop of your coilovers please. You're basically at max droop. Either lower the truck or strap the front for 0 down travel lol

 

Front suspension is about 7 in of lift

 

It’s a 5 in of lift strut with a 1in puck on top which comes out to 7 I believe with Tacomas

 

I reccomend removing the the coil spacer. Not advisable to stack lifts like that

 

Aftermarket cvs too I’m nervous about making the jump to factory as they are 700 per out here in hawaii

 

I’ll try that.

 

Can probably find some factory take offs. What island are you on? I'm moving back to Maui March of next year

 

Big island. I work at a shop so I’m waiting till one comes in for replacement and I’ll rebuild the old ones haha

 

Probably best bet. I know some aftermarket replacements such as Napa are ever so slightly shorter than factory. But yeah, I would remove the tophat spacers and go from there

 

Yeah that’s what I’ve been noticing. I even bought extended shafts hoping to rebuild the Napa ones I have to add an extra two in of length and then I can fix my alignment and have 4x4 but the splines don’t match up.