What Have You Done To Your 3rd Gen Today?

My wheels are also 16x8 with 0mm offset. I think they look great! They also ride real nice. Was expecting a bit more harshness coming from a standard load 265/70.

 

They look fantastic! I was worried they'd look strange with the 8" width as opposed to 7". I'm after the 33" tire off-road performance without the 285 gas mileage/braking impacts. Seems like 255 might be the sweet spot after seeing your pics + the other at4w/skinny threads.

 

Finally got my 3rd brake light from Tacoma Lifestyle installed. This project was a two person job. It’s in and no damage to the headliner.

 

I was in the same boat. Loved the look of 285s but the extra work alongside other drawbacks was too much for me. This is the perfect balance. With the 6 speed gearing too it helps keep the RPMs a touch lower at highway speeds.

Was about to go cooper st maxx but then these came out so i am glad i waited!

 

Put a bead of silicone around the outside edge. It's not waterproof with the included attached gasket.

 

Finally got around to doing the ARB Diff breather last weekend. Should've done it way earlier with how easy it went in. Rear diff and I can both finally breathe easier on water crossings

 

I didn't put that link there. It's this one:

$100 Hikity 10.26" Full Touch Screen Wireless Apple CarPlay Portable Car Stereo with Wireless Android Auto, Voice Control, 1080P Backup Camera, 64G TF Card, AUX Cable

https://www.amazon.com/dp/B0BVB1ZLPR

I plan to post a review after I have some more time with it.

 

Good advice. Thank you

 

What is a good silicon to use?

 

That sticker is awesome! Brake light looks good too of course

 

Permatex in clear or black works fine.

$6 Permatex 80050 Clear RTV Silicone Adhesive Sealant, 3 oz

https://www.amazon.com/Permatex-800...MIwYqMp-uXhAMVSDjUAR2DqAIQEAQYAyABEgIhEvD_BwE

 

Be nice to hear how you like them in a few thousand or so miles... I am a little ways out from swapping out my stockers (I only have 15k on the Truck), but these are on the list.... and if I recall they have them in 255/75/17 too....which I think is a nice option to gain a little diameter but drop a few pounds by going slightly narrower....and possibly better fitment.

 

I don’t think it’s a popular choice. But I replaced my cheese grater grille on my TRD OR with a SR grille. It’s what I wanted - simple and mostly black.

 

You’ll get the most benefit when the water is above the axle. Just sayin’.

 

Looks awesome! Great choice.

 

Nice job! It looks much better.

 

Hah! Pic was for attention

 

It definitely gives a peace of mind knowing it’s all the way at the top of the taillight cavity. If the waters up there you’ve got a whole different set of problems.

 

What plug did you use for the receptacle?
Might you have a link?

 

I think it looks great.