Long shot

Long shot here but these are the XD 795 and I’m just trying to figure out what kind of offset I have going on here. I was to add a bit more clearance on my UCA

 

With a tire of that apparent diameter not sure if offset even matters.

 

It’s a 285/70/17. Tire is beside truck pre lift lol. Just trying to figure out what spacer I should get and I’m rubbing my uca full turn. Thinking 6mm

 

What is the wheel size and offset?

 

When I measured the other day it’s 0 offset which leads me to believe I have a 4.5 back space. I’m thinking of ordering 6mm spacers just to get a little more clearance for the UCA

 

17x8 0offset. You don’t need a spacer. No one make a 6mm bolt on spacer. If you are set on putting a spacer imo go with Bora or Spidertrax bolt on hub centric spacers. One of them makes a 3/4” spacer.

 

+1

 

Pretty sure they’re 17x9. Could be wrong tho. On the back there’s a mark that I believe read 17x9?? But really I’m just trying to get a bit of clearance from my uca. I haven’t been for an alignment yet and it only rubs uca at full crank

 

Lift kit is installed already?

 

Bora. Makes a 3/4” spacer they’re $140 a pair. Although with a spacer that thin you made need to cut the oe studs if the wheel doesn’t have pockets on the backside that are deep enough to accept them.

 

Sure would help if you the exact specs of the wheels you bought. The offset should be stamped on the back of them along with the size.

 

Hard to see it… I think 9?? But really I just want a bit of space on the uca. Yes installed kit today but haven’t aligned yet. Wondering if maybe new uca will help?

 

So that wheel comes in a -12, 0 and and 18 offset. The 0 and -12 should not rub the uca.

 

Definitely looks like 17x9. See if you can find the offset # it should be on there. Is there a # next to the 9 ? If so can you make it out?. Look for a 0 , -12 or 18 stamped on the wheel somewhere there usually close to each other. If you can’t find I’d go with the 3/4” Bora spacer.

 

Yeah, pretty sure it’s 0 offset. But I only rub at full lock turn on the back of the uca. Other than that she’s good. I do need an alignment so not sure if that will help at all

 

Alignment may help. Size lift? If above 2” may want to get Ucas to help with proper alignment #s.

 

Still this… how’s the clearance on the bumper? Inner fender? Mud flap?

 

2.5. Did the eibach kit. And when I was doing it I noticed my ucas where looking a bit worn (230k km) so I’m looking at them now

mud flaps are off. Going to have to re shape a bit. But other than that seems good

 

utilized google a bit more and found an old brochure from when I purchased my wheels back in 2018. I must have a -12 offset on them as it is then

 

Are sayin the wheel is rubbing or the tire?