Manual Locking Hubs Part Number Question

I am in the process of rebuilding some manual hubs and getting new parts pressed into a 2nd hand pair of steering knuckles. I seem to have lost one piece that looks like a washer with cut-outs for spindles (on the right). It went behind the snap ring (on the left) that holds the CV axle to the hub. If anyone knows the part number or name I would appreciate it. I tried looking at some diagrams but didn't see it. Also, if anyone has a recommended place to get a replacement gasket which goes between the hub dial and cover I would appreciate it. I tried an O-ring but it was too thick.

 

I think you're looking for - 9056027005 and 4353160010. For reference: https://tinyurl.com/5cchrpwp

@zippsub9, can you confirm?

 

Thank you for looking that up, the spacer looks correct. I already have that seal I am looking for:


I'm pretty sure it is just an o-ring but the ones at my local hardware store were too thick and I can't get the snap ring back on to connect the dial to the hub cover.
Thank you again for your help.

 

This seems to be it. I don't know if there is a Toyota part number:

https://www.lceperformance.com/Hub-Outer-Dial-O-Ring-p/2053489.htm
https://www.ebay.com/itm/154297091838?chn=ps

 

It is a rubber ring of sorts, but not O shaped. It is more of square with some indentions on the side explaining why the hardware store O ring wouldn't work. I think Yotashop sells them as well. I'm not sure if Toyota offers that part by itself though only as a component.

 

The rubber O ring for the AISIN locking hub dial is 43532-60010 (below).

 

Thank you guys! Really appreciate the help. I will order these parts and make a post when I complete the swap.