KC Cyclones Switch Pros Sp9100 Trigger Question

What's up everyone. I've searched TW up and down and have been unable to find exaclty what I am looking for and am hoping someone can provide some insight. I'm sure this is something that has been posted a dozen times over, but apparently I am blind and can't find it lol.

I have the SP 9100 controller as well as the SP Power Tray accessory bundle (already installed) and am looking to add 6 KC Cyclone Rock Lights. My goal is to have the rock lights triggered when a door is open but can not find what I should be tapping to make this happen.

Any help would be much appreciated!

 

I can’t help you but these folks can.

@TnShooter
@caribe makaira

Good luck.

 

9. External Trigger • This function uses the PINK Trigger 1 wire and the WHITE Light input wire Trigger 2 input to turn on up to 4 outputs each. Each trigger input can be programmed to trigger on an active high (12V signal) or an active low (ground signal). • For Trigger 1, PINK wire. Connect the Pink wire to an external trigger, it can be a high beam signal, reverse light signal, or a dome light signal to give a few examples. For example, if connected to the high beam signal, when turning on the high beams on the vehicle, up to 4 outputs of the switch panel will also turn on. The function can be turned on and off, with the switch panel to switch between off-road and street driving, by holding down the programming switch and pressing switch 7. On the switch panel, hold the programming button and press switch 7. The programming led will flash 3 times, indicating the function is on. To turn the function off, press and hold the programming switch and press switch 7. The programming led will flash once, indicating the function has been turned off. • For a Trigger 2, the WHITE, “Light” wire input can be converted to a trigger input by enabling the Trigger 2 in the App. Switch panel backlighting dimming that was previously using the White wire is now activated with the Lt. Blue ignition wire signal. The Lt. Blue ignition wire is still connected to an ignition source for the ignition input, but will also turn on the backlighting to the user adjustable level. The function can be turned on and off, with the switch panel to switch between off-road and street driving, by holding down the programming switch and pressing switch 8. On the switch panel, hold the programming button and press switch 8. The programming led will flash 3 times, indicating the function is on. To turn the function off, press and hold the programming switch and press switch 8. The programming led will flash once, indicating the function has been turned off.

 

Active LOW is violet wire on Cargo Switch connector.

 

@caribe makaira - Thank you thank you!! This is exactly what I needed to know!!